Multia under Thermal Camera

(This is a guest post by Antoni Sawicki aka Tenox)

DEC Multias are known for notoriously overheating. Someone even coined a term “Multia Heat Death”. The typical folklore recommendation of the time was to only run it vertically, replace the built-in fan with a more powerful, etc.

In modern times one can inexpensively acquire a thermal camera that attaches to a mobile phone. So why not take a peak inside the inferno.

This is how Multia looks like in a thermal camera. PS is on top. CPU on the left. FDD/HDD bottom left.

The CPU, Alpha AXP, runs at around 60C, not great, not terrible.

Scanning up close through individual chips I found this curiosity:

Wedged between the memory chips and the power supply is a little chip that generates almost 100C. That’s a boiling temperature of water. Note the thermal image is shifted in regards to the visual part due to close range.

What does this chip do? I have no clue. Perhaps someone can help here. What I however did to it is this:

Slapped on this really nice radiator. In fact I added little radiators you can buy for Raspberry PI to all the chips generating tons of heat.

This is how the motherboard looks like right now:

I also added a tiny fan on top of the CPU. Drilled some holes in the case and of course replaced the main fan with a highest air flow I could find.

Time will tell if this resolves the heat death, but my Multia now runs much cooler with help of all the radiators and extra fans.

10 thoughts on “Multia under Thermal Camera

  1. I ran my Multia 24/7 from about 2005 to 2012 running NetBSD 3 hosting a PvPGN server on it. Sure it got quite hot but it never had an issue! Miss that little thing, even if it was super slow.

  2. If you get cheap heatsinks, make sure to use a glue pad that can transfer heat. A lot of the heatsinks for the raspberry pis come with standard 3m double sided tape, which is not suited for this application

  3. I’ve checked my Multia and that TC14L040 is a comfortable 35C. Something may be fishy on your part.

    However some pins on the power connector are 60C, visibly browned too! Yours seems fine.

    What a wacky little heater this machine is.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.